Plastic tubes / nylon tubings semi rigid
PA 12 HL, PA 12 PHL

Plastic tubes / nylon tubings semi rigid PA 12 HL

DIN 73378

Operative pressure for Ø 4 x 0,85 and 23°C: approx. 1044 PSI / 7 MPA / 72 bar
Operative pressure for Ø 6 x 1,25 and 23°C: approx. 1015 PSI / 7 MPA / 70 bar
Operative pressure for Ø 6 x 1,5 and 23°C: approx. 1291 PSI / 9 MPA / 89 bar

Plastic tubes / nylon tubings flexible PA 12 PHL

DIN 73378

Operating pressure:
100-005 / 100-006 approx. 39 bar / 570 PSI / 4 MPA
100-006-T approx. 36 bar / 522 PSI / 3,6 MPA
100-007 approx. 44 bar / 640 PSI / 4,4 MPA

Mounting advise:
Please do always use reinforcing sockets for plastic tubes with diameter  4x 0,85 and 6x1,25

Technical informations:

Material:

Plastic tube, semi-flexible:   PA 12 HL Plastic tube, flexible:           PA 12 PHL



Standard: DIN 73378

Material properties:
All types of plastic tubes (PA 12 HL, PA 12 PHL) are free of plasticisers, and resistant to light or heat-induced ageing.

Permissible media:
Excellent resistance to oil, grease and lubricants, and to all types of fuels and chlorine-free cleaning agents and solvents.
Application for other media than those stated above, only upon request! 

Permissible operating temperature: ca. – 60 °C to + 80 °C

The permissible operating pressures according to DIN 73378 are calculated by means of the following formula

  
                                                                                                                                     P =  20 · σV · s (Nenn)
                                                                                                                                             -----------------------
                                                                                                                                                      dm
s = nominal wall thickness [mm];
dm = da – s;
σV = reference stress N/mm2 at 23 °C

Important advice for assembly!
Our PA12HL plastic tubes according to DIN 73378 in the dimension 6x1.5 (i.e. 6 mm outer diameter and 1.5 mm wall thickness = 3 mm inner diameter) are also referred to as poly tube 6x3. For these tubes, use of a push-in socket is not required. Assembly together with a cutting ring fitting, equal to use of our push-in fitting, is easy and straight forward.

In contrast to that, push-in sockets or reinforcement sockets must be used for PA 12 PHL polyamide tubes with wall thickness of 0.85 mm.

Please note that push-in sockets that are "lost" or "forgotten" during assembly, may result in severe problems and major damage.

As a general rule, we recommend using push-in sockets if the wall thickness of a plastic tube is In our capacity as manufacturer, we would like to make our customers aware that assembly of our components for central lubrication (tubes, hoses, screw fittings, ...) must only be performed by appropriately trained and qualified personnel.

In borderline cases, it is advisable to consult us beforehand. Have the tubes mounted only by qualified and/or accordingly trained personnel.

The warranty claims are limited to the specification of this technical data sheet. Further warranties will not be accepted.